亚洲欧美综合区自拍另类,日韩欧美视频在线,日本一区二区三区在线网,综合欧美亚洲日本

熱線電話
0531-69951198
網站首頁
關于精拓
產品展廳
新聞中心
原理選型
客戶案例
在線留言
聯系我們
網站公告:

新聞中心

濟南精拓流體設備有限公司

電話:0531-69951198

郵箱:jingtuolt@163.com

傳真:0531-69951198

地址:濟南市歷城區祝甸北路2號院

網址:http://m.liqun518.com

企業動態

當前位置:首頁 - 新聞中心 - 企業動態增壓泵自助選型的四個問題

增壓泵自助選型的四個問題

發布時間:2022-12-31 16:38:12   發布人:http://m.liqun518.com
增壓泵分為氣液增壓泵,氣體增壓泵,原理是利用大面積活塞的低氣壓產生小面積活塞的高液壓。增壓泵自助選型應注意事項有哪些呢?先從四個問題了解起來。
Booster pump is divided into gas-liquid booster pump and gas booster pump. The principle is to use the low pressure of large area piston to generate high hydraulic pressure of small area piston. What should be paid attention to in self-service type selection of booster pump? Let's start with four questions.
1.增壓的是介質是什么?
1. What is the pressurized medium?
液體:如清水、液壓油、航空煤油、乳化液等,則選擇氣液增壓泵
Liquid: such as clean water, hydraulic oil, aviation kerosene, emulsion, etc., gas-liquid booster pump shall be selected
氣體:空氣、氮氣、氧氣、氦氣等氣體,則選擇氣體增壓泵
Gas: air, nitrogen, oxygen, helium and other gases, then select the gas booster pump
兩類泵雖然原理相同,但其結構不同,所以不能混用。
Although the two types of pumps have the same principle, their structures are different, so they cannot be mixed.
2.被增壓介質增壓前的壓力是多少?
2. What is the pressure before being pressurized by the pressurized medium?
對于氣液增壓泵,液源無需壓力,依靠泵自身的自吸能力即可將介質吸入泵中進行增壓;
For gas-liquid booster pump, the liquid source does not need pressure, and the medium can be sucked into the pump for pressurization depending on the self-priming capacity of the pump itself;
對于氣體增壓泵,須知道介質的進氣壓力,這絕定的后面的正確選型,如果輸出壓力在8MPa以上,進氣壓力小于1.2MPa則需選用雙級氣體增壓泵HGT系列,對于HGS系列、HGD系列增壓比10:1以上的,
For the gas booster pump, the inlet pressure of the medium must be known, which determines the correct model selection. If the output pressure is more than 8MPa and the inlet pressure is less than 1.2MPa, the two-stage gas booster pump HGT series must be selected. For the HGS series and HGD series with a boost ratio of more than 10:1,
氣體增壓泵
進氣須有較高的預壓,如氮氣瓶等。
The intake air must have high pre pressure, such as nitrogen cylinder.
3.被增壓介質的溫度是多少?
3. What is the temperature of the pressurized medium?
增壓泵一般不適用于高溫流體的增壓。
Booster pumps are generally not suitable for pressurization of high-temperature fluids.
4.如果是壓力檢測,被打壓的產品容積是多少?
4. If it is a pressure test, what is the volume of the product being pressurized?
如果沒有具體數據,可以選擇相對等的常見容積進行描述,但不可告知,不大、很小等詞語,因大小是個相對概念,對選型沒有任何幫助。
If there is no specific data, you can choose relatively equal common volumes to describe, but you can't tell. Words such as small and very small are not helpful for selection because size is a relative concept.
增壓泵自助選型的四個問題就是以上概括的內容了,您對此有怎樣的想法或者疑惑,就來我們網站http://m.liqun518.com進行咨詢吧!
The four questions about self selection of booster pump are summarized above. If you have any ideas or doubts, please come to our website http://m.liqun518.com Consult!
新聞: